0

FIN EC

Online nápověda

Stromeček
Nastavení
Program:
Jazyk:

Forces

The internal forces in the certain member point can be entered with the help of this window. These properties can be specified:

x

  • Basic input, that specifies the position of the point along the member length. The position is measured from the left end of the member

N

  • Normal force

M2

  • Bending moment about axis 2 (positive values represent tension in the bottom edge of the cross-section)

M3

  • Bending moment about axis 3 (positive values represent tension in the left edge of the cross-section)

V3

  • Shear force in vertical direction (parallel with axis 3)

V2

  • Shear force in horizontal direction (parallel with axis 2)

Values of all internal forces shall be specified only in the first (x=0) and last (x is equal to member length) sections. Intermediate sections may contain unfilled certain internal forces. The values of these forces are obtained with the help of linear interpolation using the closest values that were specified in other sections.

Window "Force edit"

Vyzkoušejte si zdarma náš software.
Stáhněte si aktuální Edici zdarma.