0

FIN EC

Online nápověda

Stromeček
Nastavení
Program:
Jazyk:

Cross-section edit

The geometry of steel cross-section can be specified in this window. The window contains cross-section preview and these buttons for cross-section input:

Rolled, Welded, Solid, Rolled composite

  • The input of cross-sections that are considered as compact during the design. The geometry is defined in the window "Cross-section editor". The cross-section properties are also described in the chapter "Cross-sections" of theoretical part of the help.

Rolled built-up, Welded built-up

  • The input of built-up cross-sections (built-up members consist of two or four partial cross-sections that are connected by battens or lacing). The geometry of partial cross-sections is defined in the window "Cross-section editor". The cross-section properties of built-up cross-sections are also described in the chapter "Cross-sections" of theoretical part of the help.

User defined

  • The general input of cross-sectional characteristics.

Editor

  • The option for the input of arbitrary geometry of the cross-section in the program "Section". Analysis of these cross-sections is described in the theoretical part of help.

Details

  • Shows detailed cross-section characteristics in a new window

The cross-section can be rotated about its axis 1 using input line "Rotation". This feature can be used for cases where the load isn't applied in the directions of the main cross-section axis (e.g. purlins). The cross-section properties are also described in the chapter "Cross-sections" of theoretical part of the help.

The analysis method may be also specified here:

Plasticity according to class

  • The verification method is performed according to the automatic classification of the cross-section. Available only for cross-sections from pre-defined database.

Non-plastic calculation

  • The plastic resistance of the cross-section isn't considered during the design, even if the cross-section is classified as class I. or II. Analysis is performed according to the rules for classes III. or IV. Available only for cross-sections from pre-defined database.

Elastic calculation

  • The verification of the cross-section with the help of the elastic resistance. Available only for cross-sections created in the software "Section".

Plastic calculation

  • The verification of the cross-section with the help of the plastic resistance. Available only for cross-sections created in the software "Section".

The setting "Cold formed" affects the selection of an appropriate buckling curve in accordance with the table 6.2 of EN 1993-1-1.

The shear areas Avy, Avz for shear verification in directions y and z have to be specified for cross-sections created in the program "Section". The setting "Estimate shear areas" divides the total area of the cross-section uniformly.

Window "Cross-section edit"

Vyzkoušejte si zdarma náš software.
Stáhněte si aktuální Edici zdarma.