Odkaz jsme Vám odeslali na email.

Nepodařilo se nám odeslat odkaz na váš email. Zkontrolujte, prosím, Váš email.

Online nápověda




In stability (safety factor) analysis the program reduces the original strength parameters - angle of internal friction and cohesion - until failure occurs. The analysis then results into a factor of safety that corresponds to the classical methods of limit equilibrium.

The safety factor analysis requires using six-node elements. Since plastic slip is the main failure mechanism we also require that the Mohr-Coulomb, the modified Mohr-Coulomb or the Drucker-Prager plasticity model be used for all soils. Default setting can be adjusted in the "Analysis settings" dialog window.

In the stability analysis mode the only variables available for graphical representation are displacements (in the Z and X-directions) and equivalent total and plastic strains. The deformation of a soil body corresponds to the state of failure attained for the reduced soil parameters - therefore, it does not correspond to real state of deformation of the soil body. Instead, it provides a good insight about the entire slope response of earth structure in general at the onset of failure.

A suitable way of presenting the stability analysis results are vectors of displacements plotted together with the equivalent plastic strain. The localized plastic deformation provides visible evidence about the possible location of the critical slip surface.

The program allows to analyse a slope stability according to theory of limit state or EN1997-1, design approach 3. In the frame we enter partial factor on internal friction γM,ϕ and partial factor on effective cohesion γM,c, which reduce soil parameters. If we use reduction according to EN 1997 (γM,ϕ = 1,25, γM,c = 1,25), the slope is satisfactory for FS=1,00.

Frame "Stability"

Plot of equivalent plastic strain - slip surface